How do I start and set up my Patio & Wall Cleaner

Quick Answer

To set up your patio and wall cleaner, assemble the tube sections securely, attach the unit to your pressure washer gun using the correct adaptor, and ensure all connections are tightly fitted. Once connected, you can begin cleaning by moving the unit in smooth, straight passes across the surface, adjusting pressure using the top control dial.

Before You Start

Before assembling or using your patio cleaner, make sure:

• The pressure washer is switched off
• All components are dry
• You are wearing suitable PPE if required
• The working area is clear of obstacles

Always:

• Inspect the patio cleaner for cracks or damage
• Ensure all fittings are clean before connecting
• Check compatibility with your pressure washer model

Important: Do not connect or disconnect any parts while the system is pressurised.

Specifications

This patio and wall cleaner is designed to operate within the following limits:

• Maximum permissible pressure: 15 MPa
• Maximum inlet water temperature: 60°C
• Recommended operating pressure: 90–150 bar

Important: Using the cleaner outside these limits may affect performance or cause damage.

How to Set Up the Patio & Wall Cleaner

1. Assemble the tube sections

• Connect all tube parts together
• Push each section firmly into place
• Twist to lock securely

Tip: Ensure each section is fully seated before moving on.

2. Attach tubes to the cleaner head

• Push the assembled tube into the cleaner unit
• Twist until it locks securely in place

[Insert image of cleaner head attachment]

3. Connect to your pressure washer gun

Depending on your model:

Workzone pressure washers:

• Insert the top of the extension tube into the spray gun
• Twist the gun clockwise and tube anti-clockwise until secure

Non-Workzone pressure washers:

• Use adaptor E for common DIY spray guns (up to 150 bar)
• Use adaptor H for compatible Workzone/DURA models (post-2012)
• Ensure the correct adaptor is firmly fitted before use

How to Start Using the Patio Cleaner

Once assembled and connected:

• Place the cleaner flat against the surface
• Start the pressure washer
• Move the unit in straight lines, either:
  • Up and down
  • Left and right

Avoid circular movements for best cleaning results.

How to Adjust Cleaning Power

The top dial controls cleaning intensity:

• Turn clockwise to reduce pressure
• Turn anti-clockwise to increase pressure

Adjust gradually until you reach the desired cleaning effect.

Important Safety Measures

• Always check for damage before each use
• Do not handle wet electrical connections
• Keep hands away from spray area during operation
• Ensure all connections are secure before starting
• Never exceed recommended pressure limits

Frequently Asked Questions

Why won’t my patio cleaner connect to my pressure washer?

This is usually due to using the incorrect adaptor or an incompatible gun type.

Can I use the patio cleaner at full pressure?

It should only be used within the recommended 90–150 bar range to avoid damage.

Why is my patio cleaner not spinning properly?

This can be caused by low water flow, trapped air, or incorrect pressure settings.

Do I need an adaptor?

Yes, depending on your pressure washer model, either adaptor E or H may be required.

How should I move the patio cleaner when in use?

Always use straight-line movements for the most even and effective cleaning result.